|
The Breaksafe Breakaway System has been designed to activate the electric brake system and brake lights on all caravans, travel trailers, trailers, horsefloats and campers in the event of an accidental separation (e.g. Breakaway).
The Breaksafe will not only apply the electric brakes and the brake lights of the trailer, but will keep them applied for around 20 minutes, enabling you to secure your trailer when it has come to a stop.
The Breaksafe has its own power supply, which charges via an auxiliary line while driving, or it can be charged externally with a battery charger. It also has a battery condition indicator, allowing you to tell the condition of the battery, with the push of a button.
The Breaksafe kit comes complete with battery, breakaway switch and all mounting hardware, as well as full installation instructions.
PART NUMBERS
BREAKSAFE 5000 - 2 & 4 wheel electric brake.
BREAKSAFE 5000XP - 6 wheel electric brake.
BREAKSAFE 5000 AND 5000XP FITTING INSTRUCTIONS
BREASAFE OPERATING INSTRUCTIONS
BREAKSAFE RM6000 - Remote Battery Monitor
AS REQUIRED BY LAW FOR TRAILERS REGISTERED IN NSW
FOR NSW REGULATIONS CLICK HERE
The remote battery monitor is fitted to the dash of the tow vehicle and checks the condition of the Breaksafe battery each time the brake pedal is pressed. Should the battery be low, a red light will illuminate on the front panel of the 5000RM and a buzzer will sound for about 10 seconds.
A green light indicates the battery is good.
BREAKSAFE RM6000 REMOTE MONITOR FITTING INSTRUCTIONS
BREAKSAFE 5000CI - Charge Isolator
The Breaksafe Charge Isolator is for caravans and trailers that have onboard batteries. The Breaksafe Charge Isolator has an inbuilt electronic movement and vibration sensor which switches the 12 volt charge circuit of the Breaksafe "on" only when the vehicle is moving and turns the charge circuit "off" when the vehicle stops.
This elliminates constant drain from the onboard batteries when the vehicle is not being towed.
BREAKSAFE 5000CI CHARGE ISOLATOR FITTING INSTRUCTIONS
| 
